Pullup & Dip Wall Mounted Pull-Up Bar - User Instructions; Mounting Location Requirements; Check Wall for Utilities; Maximum Weight Limit

18
1. The product can only be mounted to massive walls (as for example concrete or brick
walls) that can withstand the loads and forces generated by the use of the pull-up bar.
Hollow or plasterboard walls are not suitable for mounng!
2. Before drilling holes in the wall, consult with your landlord and a professional about
the roung of power supply lines and water pipes in the wall to avoid causing dama-
ge. If you are unsure about the condion of your wall and/or the use of anchors and
screws, you should seek the advice of an expert for advice.
3.
4. The maximum weight limit of 200 kg (440 lbs) must not be exceeded at any me!
5. Please use only the handles of the pull-up bar (handle bar and parallel handle) during
your workout.
6. Do not hang upside down from the pull-up bar! Do not hang from the pull-up bar by
your legs or feet!
7. Always perform the dierent variaons of pull-up exercise with straight posture and
with controlled (i.e. not swinging or abrupt) movement of your body.
8. Please note that FT Fitness Technology GmbH does not accept any liability for damage
caused during or as a result of improper assembly, use or exceeding weight limits.
2| User instructions
Store your device indoors. When storing the device, avoid exposing it to direct sunlight or
moisture and keep it away from heat sources.
Clean the device and the handles with a damp, so and clean cloth. Do not use any abra-
sive, corrosive, acidic or alkaline cleaning agents, as these may damage the surface of the
device or cause scratches.
3| Storage and maintenance