LCDM-2000
1-3-5. Bill-End Detection
The Bill-End detection can be decided by dip switch (the 1
st
switch on the SW1).
If you set the switch “ON”, the unit continues to dispense until approximately
10~30 bills remains, and then Bill-End sign will displayed with stopping the unit.
Else if you set the switch “OFF”, the unit continues to dispense until none of bills
remain, and then Bill-End sign will displayed with stopping the unit.
There is hole in the front of “Cash Cassette” and detection process is done
by this hole. ( Please refer to the layout of sensor for location)
To Next Page
Loading...