WIRELESS REMOTE CONTROL
(bought separately)
21
Wireless remote control (RC) duplicates the POWER ON function,
digital zoom, video start/stop and menu navigation.
18
19
20
17
Brief press Enter quick
menu
Turn on
device /
Calibrate
sensor
Controller
(17)
Button
ON (18)
Activate
discrete
zoom
Button
ZOOM (19)
Start video
recording
Button
REC (20)
Long press Enter main
menu
Display Off /
Turn off
device
Activate
function PiP
Switch
between
video/photo
modes
Clockwise
rotation
Increase
parameter,
move upwards
Counter-
clockwise
rotation
Decrease
parameter,
move
downwards
TECHNICAL INSPECTION
22
Check:
Connection modes:
Memory card (external memory). In this mode the device is
detected by the computer as a flash card. This mode is designed for
work with the files saved in device's memory. The device's functions
are not available in this mode; the device turns off automatically.
If video recording was in progress when connection was made,
recording stops and video is saved.
When USB is disconnected from the device where connection is in
the USB Mass storage device mode, the device remains on the OFF
state. Turn the device on for further operation.
Power.
Note: The Battery pack installed in the device is not being charged!
In this mode PC/laptop is used as an external power supply. The
status bar shows icon . The device continues operating and all
functions are available.
When USB is disconnected from the device when in the Power mode,
the device keeps operating with Battery Pack, if available, and it has
sufficient charge.
The state of the objective and eyepiece lenses (there should be no
cracks, spot, dust, deposits etc. ).
External view (there should be no cracks on the housing).
The state of the Battery Pack (should be charged) and electric
terminals (there should be no oxidation ).
Correct functioning of the controls.
23
Maintenance should be carried out no less frequently than twice a
year, and should consist of the following measures:
Store the device in a carrying case. Remove the Battery Pack
Clean the electric terminals of the Battery Pack and device's
battery slot using a grease-free organic solvent.
Check the objective and eyepieces lenses. If required, remove dust
and sand (preferably by a noncontact method). Clean the external
surfaces of the lenses with products expressly designed for this
purpose.
for long-term storage.
Wipe external plastic and metal surfaces clean of dust and dirt with
a soft cloth moistened with a synthetic cleaning agent.
MAINTENANCE AND STORAGE
26
25
To Next Page
Loading...
Need help?
General
