Pulsar HELION 2 XP50 User Manual

Battery pack charging
Lift up the lever (7) of the charger.
Install the Battery Pack (5) into the charger as far as it can go.
Lower the lever (7).
Connect the micro USB plug of the USB cable (8) to the micro USB port (9) of the charger.
Connect the other end of the microUSB cable to the mains adapter (10).
Plug the mains adapter (10) into a 100 – 240 V socket (11).
Disconnect the charger from the mains after the battery is fully charged (green LED light stays on continuously).

Pulsar HELION 2 XP50 Specifications

General

Sensor Resolution	640x480
Pixel Pitch	17 µm
Display Type	AMOLED
Display Resolution	1024x768
Magnification	2.5 - 20x
Detection Range	1800 m
Frame Rate	50 Hz
Waterproof Rating	IPX7
Objective Lens	F50/1.2
Dimensions	234x55x58 mm
Built-in Memory	16 GB
Thermal Sensitivity	<40 mK
Field of View	12.4° x 9.3°
Digital Zoom	4x
Power Supply	Li-Ion battery
Operating Temperature	-25°C to +50°C
Video / Photo Resolution	640x480
Video / Photo Format	MP4 / JPG
Battery Life	8 hours