Pulsar PTG12205 - Product Specification; Safety & Instruction Decals; Setup Procedures; Unfolding the Handle

Setup
Important:
Remove and discard the
protective plastic sheet that covers the engine.
1. Unfolding the Handle
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
Important: Safety &
instruction decals are
located near areas of
potential DANGER.
Replace damaged decals.
2.Attaching Wheels (See Figure 2)
•
Parts needed - 2 front wheels (7"), 2 rear
wheels (11"), 4 washers and 4 nuts.
Install the washer into wheel axle then put
on the wheel into wheel axle.
Screw lock nut into the end of the thread of
the wheel axle until it locks into place.
Repeat process on the other side of the
lawn mower to install the other three wheels.
•
•
•
Figure 2
Product Specification
Component
Rated Speed
Displacement
Cutting Width
Height Adjustment
Wheels
Machine Weight
Safety & Instruction Decals
1. WARNING: Read the Operator’s Manual.
2. Thrown Object Hazard: Keep bystanders a safe distance
from the mower.
3. Cutting/Dismemberment Hazard of Hand or Foot, Mower
Blade: Disconnect the spark plug wire and read the
instructions before servicing or performing maintenance.
4. Cutting/Dismemberment Hazard of Hand or Foot, Mower
Blade: Stay away from all moving parts and keep all
guards and shields in place.
5. Cutting/Dismemberment Hazard of Hand or Foot, Mower
Blade: Do not mow up and down slopes, only mow
across; stop the mower and engine, pick up debris before
operating; look behind and down before reversing.
•
•
Do not pinch or bend cables when folding or unfolding
the handle.
If a cable is damaged, Contact an Authorized Service
Center by calling 866-591-8921.
Specification
2800RPM
150cc
20”
1”- 3”
7” Front 11” Rear
60 lbs
1. Remove the handle knobs from the mower deck.
Important: Route the cables to the outside of the handle as
you install the handle.
1. Handle knob (2)
2. Move the handle to the operating position.
3. Install and tighten the handle knobs that you removed
in step 1. (Figure 1)
2. Filling the Engine with Oil
1. Remove the dipstick.(Figure 3)
Figure 3
3
1
Figure 1
• Then place wheel cover by tapping it in.
Your mower engine does not come filled with oil. Use
SAE 30 weight engine oil (not included)
2. Slowly pour oil into the dipstick/fill hole until the oil level
reaches the full range on the dipstick. Do not overfill.
Max 13.5oz. (0.4L), type: SAE 30 weight engine oil
with an API service rating of SF or higher.
H
L
WARNING