17
OPERATION
4. Once the engine is running, put the starter rope Into
the rope guide. As shown in Fig 17
Stopping The Engine
As shown in Fig
18
Releasing the engine start/stop lever will shut the engine off.
To Clean A Flooded Engine
1. Release the engine start/stop lever to stop engine.
2. Remove the spark plug, dry it, and then reinstall it.
3. Pull the engine start/stop lever toward upper handle.
4. Operate the pull start as described above.
If the engine won’t start after you have
pulled the starter several times, the
NOTE!
Fig
17
Fig
18
engine may be flood with excess fuel. Use following procedure
to clear and start a flooded engine.
Install the spark plug carefully by hand,
to avoid cross-threading. After the plug is
NOTE!
seated tighten 1/8 to 1/4 turn with socket spanner of spark
plug to compress the washer.
To Next Page
Loading...
Need help?
General
