English
English
1110
TO PRESERVE THE QUALITY OF YOUR WATCH
* Before using the water resistance 5, 10, 15 or 20 bar watch in water, be sure the
crown is pushed in completely.
Do not operate the crown when the watch is wet or in water. If used in sea water,
rinse the watch in fresh water and dry it completely.
* When taking a shower with the water resistance 5 bar watch, or taking a bath with
the water resistance 10, 15 or 20 bar watch, be sure to observe the following:
• Do not operate the crown when the watch is wet.
• If the watch is left in warm water, a slight time loss or gain may be caused. This
condition, however, will be corrected when the watch returns to normal tem-
perature.
NOTE:
Pressure in bar is a test pressure and should not be considered as cor-
responding to actual diving depth since swimming movement tends to
increase the pressure at a given depth. Care should also be taken on
diving into water.
TEMPERATURES
Temperatures over 50° C (122° F)
may cause battery leakage or shorten
Your watch works with
stable accuracy within a
temperature range of 5
° C and 35° C (41° F and
95° F).
the battery life. Do not leave your
watch in very low temperatures be-
low –5° C (+23° F) for a long time
since the cold may cause a slight
time loss or gain.
However, the above conditions will
be corrected when the watch returns
to normal temperature.
WATER RESISTANCE
l
Non-water resistant
l
Water resistance (5 bar)*
If “WATER RESISTANT 5
BAR” is inscribed on the
case back, your watch is
designed and manu-factured
to withstand up to 5 bar and is suitable
for swimming, yachting and taking a
shower.
If “WATER RESISTANT 10
BAR”, “WATER RESISTANT 15
BAR” or “WATER RESISTANT
20 BAR” is inscribed on the
l
Water resistance (10 bar/15 bar/20 bar)*
case back, your watch is designed and
manufactured to withstand up to 10 bar/15
bar/20 bar and is suitable for taking a bath,
shallow diving, but not for scuba diving.
We recommend that you wear a PULSAR
Diver’s watch for scuba diving.
If “WATER RESISTANT” is
not inscribed on the case
back, your watch is not water
resistant, and care should be
If “WATER RESISTANT” is
inscribed on the case back,
your watch is designed and
manufactured to withstand
l
Water resistance (3 bar)
up to 3 bar, such as acci dental contact
with splashes of water or rain, but it is not
designed for swimming or diving.
taken not to get it wet as water may damage
the movement. If the watch becomes wet,
we suggest that you have it checked by an
AUTHORIZED PULSAR DEALER or SERVICE
CENTER.
To Next Page
Loading...
Need help?
General
