Puqpress M2 - 4 Set-Up and Basic Adjustment; Adjustment of Port-A-Filter Clamp

7
EN
Precision coee tamper
6 Display
7 Fine adjustment wheel
8 ON/OFF switch
9 Bottom side: power entry
10 tag label
4 Set-up and basic adjustment
You have received your tamper in operating condition. Now you only
need to adjust the port-a-lter clamp, connect the tamper to the
power grid and insert drip tray. Proceed as follows:
4.1 Adjustment of port-a-lter clamp
The tamper is designed so that all dierent portalter from various
espresso machines t into the clamp (pos. 3 & 4 ) for even and level
tamping.
If the portalter clamp is not correctly adjusted, even and level
tamping cannot be guaranteed!
Proceed as follows for adjustment of the portalter clamp:
1. Retract the power cord from the socket at the bottom side.