Puqpress M2 - Usage Location; Set-Up with Mythos

9
EN
Precision coee tamper
5. Remove the port-a-lter and fasten the screws rmly.
6. Try to insert the portalter in the clamp and check if the port-a-
lter slides in the clamp easily. If the adjustment of the clamp is
too loose, start again at step 2.
7. The portalter should not wiggle!
4.2 Usage location
Place the tamper on a level, vibration-free surface.
Never operate the tamper in moist, or even worse, in wet
surroundings!
4.3 Set-up with Mythos
For a safe set-up with the Mythos grinder, make sure you
handle it with 2 people with care.