PURE Evoke H4 - Device Setup; Rear connections explained; Initial Evoke H4 setup

6
Rear connections
12V DC 1.2A
x inAu
Input for supplied
mains adapter only
3.5mm output for
stereo headphones
Analogue stereo
input for auxiliary
cables
Micro USB
connector for
software updates
Setting up your Evoke H4
To set up your Evoke H4:
1. Unclip the aerial and fully extend it.
2. Connect the supplied mains adapter to the input on the back of your Evoke H4.
3. Plug the mains adapter into the mains supply.
>
+
–
12V DC 1.2A Aux in
+
–
12V DC 1.2A Aux in
+
–
12V DC 1.2A Aux in