Plug the mains adapter into the mains supply and press the standby button.
Start
Quick set up
Quick set up > Overview of controls and connectors > Symbols on the screen
Start
Wait until Siesta completes an Autotune for available radio stations (about a minute).
Set energy saving mode.
Press the select button when you see the message ‘Enable energy saving?’.
Press select again to switch on energy saving mode.
When energy saving mode is switched on, the radio uses less power in standby because
it does not collect and store Intellitext messages in standby. It still collects and stores
Intellitext messages while the radio is switched on (see page 11).
With energy saving mode switched on, the power consumption of Siesta in standby is
less than 1 Watt.
For more information: Intellitext > page 9 energy saving mode > page 11
Uncoil the aerial wire and hang it vertically, then connect the mains adapter to the
bottom of the unit as shown.
To Next Page
Loading...
Need help?
General
