READ AND FOLLOW ALL INSTRUCTIONS
ATTENTION INSTALLER: This manual contains essential information about the installation, operation,
and safe use of this pool pump. Please remember to furnish this manual and all other instructional
documents to the end user of this product.
Failure to read and follow instructions can result in serious injury.
To prevent potential injury to self or product and to avoid u
nnecessary service calls, please read the
manual carefully. Look for the following symbols and signal words and be alert to potential injury.
WARNING- This is a safety-alert symbol. Whenever you see this symbol in this manual or
on the pump itself, look for the following signal words to alert potential dangers.
DANGER- A licensed electrician MUST complete, in full, all electrical installation
CAUTION- Th
is represents a potentially hazardous and dangerous situation. If not careful,
it may result in bodily or property damage.
IMPORTANT SAFETY INSTRUCTIONS
General Warnings
● Never open the inside of the drive motor enclosure.
● The pump is not submersible.
● Install this pump in a place with good drainage
● Before starting, all system valves must be in a position that allows water to return to the pool.
● Code re
quirements for the electrical connection differ from state to state. Install equipment
according to the National Electrical Code.
● Switch pump to OFF by disconnecting the main circuit to pump BEFORE servicing pump
WARNING- To reduce the risk of injuries, do not permit children to use this product unless
supervised.
WARNING- Risk of electrical Shock. Connect only to a circuit branch protected by
aground-fault circuit interrupter (GFCI). If you cannot verify if the circuit is protected by a GFCI, contact
a qualified technician. Pump must be permanently connected to a GFCI.
To Next Page
Loading...
