WARNING- This unit must only be connected to a supply circuit that is protected by a
ground-fault-circuit protection (GFCI). The GFCI should be provided by the installer and should be
tested on a routine basis. To test the GFCI, simply push the test button. The GFCI should interrupt
power. Push the reset button and the power should be restored. The GFCI is defective if it fails to
operate in this manne
r. If the GFCI interrupts the power to the pump without the test button being
pushed, this indicates a ground current is flowing and has the possibility of causing an electric shock.
Do not use the pump. Disconnect the pump and correct the issue with a qualified service technician
before using.
WARNING- To reduce the risk of electric shock, immediately replace damaged cords.
WARNING- This pump is only f
or use with permanently-installed pools and may be used
with hot tubs and spas, if so marked. Do NOT use with storable pools. A permanently-installed pool is
constructed in or on the ground or building, such that it is capable of being readily disassembled for
storage and reassembled to its original integrity.
WARNING- Hazardous Pressure- During startup, normal operation, and after pump shuts
off, the po
ol and spa water circulation system operates under hazardous pressure. Please stand clear
of the circulation system during pump start-up. Before servicing your pool equipment, make sure all
systems and pump controls are in the off position and the filter manual air relief valve is open. Also
make sure all system valves are set in a position that allows water to return to the pool. Do not change
the fi
lter valve position while the system pump is running. All suction and discharge valves must be
open when starting the circulation system. Failure to follow safety and operational instructions could
result in damage, severe personal injury, or death.
WARNING- Separation Hazard- Please ensure the strainer cover is properly secured to
the pump housing. Do not operate pool and spa circulation systems if a
system component is not
assembled properly, damaged, or missing. All suction and discharge valves must be open when starting
the circulation system. Failure to follow safety and operational instructions could result in damage,
severe personal injury, or death.
Pump Overview
This manual contains essential information about the installation, operation, and safe use of this pool
pump. Failure to install ac
cording to the defined instructions will void your warranty.
To Next Page
Loading...
