Helm Systems
2-5
Section 2
C280 / S280 / C310 / ST310
When new, or after repairs, hydraulic steer-
ing systems may need to be purged of air.
Refer to the information provided with the
steering system for specifications and ser-
vice information. Check steering operation
and visually inspect for loose or missing
hardware before operating the boat. If you
suspect the steering system is damaged,
see your Pursuit dealer. DO NOT operate
the boat if you suspect the steering system
is malfunctioning.
Trim Tab Maintenance
Marine growth can affect the operation of the
trim tab planes and actuators. To help
reduce marine growth, return the trim tabs to
the full “UP” position after operating the
boat. Inspect and clean the actuators and
planes regularly.
The trim tabs also include a zinc anode to
help prevent galvanic corrosion. Galvanic
corrosion occurs when different metals are
submerged in an electrolyte. Sea water is an
electrolyte and submerged metal compo-
nents must be protected. Anodes were fac-
tory installed and need to be replaced when
they are 75% of their original size.
Refer to Routine Maintenance for informa-
tion regarding zinc anodes and the trim tab
owner’s manual for additional maintenance
information, fluid specifications and operat-
ing instructions.
! WARNING
LOSS OF CONTROL AND UNSAFE
BOAT HAZARD
Improper maintenance of steering
system is hazardous and can cause
death or serious injury from sudden
loss of control. Make sure all steering
hardware, cables and fluid levels are
regularly inspected and maintained.
DO NOT attempt to service any part of
the steering system unless you are
familiar or qualified to do so. Follow
all instructions regarding mainte-
nance procedures in the steering sys-
tem owner’s manual.
To Next Page
Loading...
