2. Connect Power
Remove the Mantis from its packaging and set it down on a nice flat surface. Remove the
end-caps from their plastic bags and clip them on to the ends of the Mantis. They are
magnetic.
Remove the Power supply from its box – you will find it inside of one of the foam end
pieces in the box. Have a look through the included interchangeable heads and select
the correct one for your country. Carefully clip this on.
Make sure the Mantis is switched off.
Connect the small end of the wire to the power socket on the back of the Mantis and
plug the Power Supply in to an available mains socket.
Switch on Mantis and you will see quite a few of the LEDs light up. The 2 LFO LEDs will
be pulsing.
Note: Mantis can be bus-powered from USB if that is more convenient. We recommend
using the Power Supply first time though to make sure everything is working correctly.
5
To Next Page
Loading...