Middle
(Green LED
is flashing)
High
(Green LED
flashes quickly)
Low
(Green LED
flashes slowly)
17
will be cleared out after all program setting
been cleared out.
Program Pedals as Y axis
1.Press SHARE. Hold for 3 seconds until the
green LED is on.
2.Press LEFT of the D-PAD. The green LED is
off. Pedals are programmed as Y function.
Program L-Wing and R-Wing as Y axis
1.Press SHARE. Hold for 3 seconds until the
green LED is on.
2.Press RIGHT of the D-PAD. The green LED is
off. Pedals are programmed as Y function.
3 levels wheel sensitivity adjustment
1.Press SHARE + OPTIONS at the same time.
Hold for 3 seconds until green LED is on.
Release the button.
2.Press SHARE again. Current sensitivity is
displayed
3.Press SHARE a third time to select
sensitivity level. It cycles as below:
4.Press UP of the D-PAD to confirm and quit.
To Next Page
Loading...
