Pyle Pro PLTTB-1 - Installation Guide; Installing the Turntable Platter

PYLE PRO PLTTB-1 Stereo Turntable
Installing the Turntable Platter:
NOTE: Your turntable may already have the platter installed. If not, follow the
installation instructions below.
Remove the platter (3) from the packaging.
Place the platter over the center spindle of the turntable.
Rotate the platter by hand until one of the cutouts is close to the stroboscope lamp (4)
and the drive axle (inside the turntable) can be seen through the cutout.
Reaching through the cutout of the platter, grasp the drive belt and pull it over the drive
axle.
Place the supplied rubber mat onto the turntable platter.
3