Pyle Pro PLTTB-1 - Installing the Counterweight; Setup and Calibration; Setting the Stylus Pressure

PYLE PRO PLTTB-1 Stereo Turntable
Installing the Counterweight:
Remove the counterweight (6) from the packaging.
Hold the tonearm (10) near its mid-point with one hand.
With your other hand slide the counterweight onto the end of the tonearm until it is fully
seated.
Setting the Stylus Pressure:
Set the antiskating control (7) to the “0” position.
Remove the stylus protection cap by gently pulling it down, away from the top of the
headshell (12).
Note: Replacement cartridges are available from your PYLE PRO dealer.
4