ww w.PyleUSA.com
3
14. Before placing, installing, rigging, or suspending any product, inspect all hardware,
suspension, cabinets, transducers, brackets and associated equipment for damage.
Any missing, corroded, deformed, or non-load rated component could signicantly
reduce the strength of the installation, placement or array. Any such condition
severely reduces the safety of the installation and should be immediately
corrected. Use only hardware which is rated for the loading conditions of the
installation and any possible short-term, unexpected overloading.
Never exceed the rating of the hardware or equipment.
15. Consult a licensed, professional engineer regarding physical equipment installation.
Ensure that all local, state and national Regulations regarding the safety and
operation of equipment are understood and adhered to.
16. Refer all servicing to qualied service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or
has been dropped.
Introduction
To get the most from the Wireless BT Streaming Amplier, it is recommended
that you review all of the information provided in the instruction manual before
operating the equipment.
ATTENTION
1. A: Connect the audio input with the CD/DVD/TV audio output.
NOTES:
• These jacks does not support video signal, so make
sure that the CD/DVD/AUX terminal are connected.
• Noise will be heard when you connect the unit with
CD/DVD/TV video output by mistake.
2. B: Signal output that can be connected with other
amplier or speakers that comes with an Amp.
3. STEPS FOR FM RADIO CONTROL
A. Connect the FM antenna before using the FM radio.
B. Press MODE button on the front panel or remote control to select FM mode.
C. Press PLAY/PAUSE button on the front panel or remote control, and will auto
scan and sore FM Radio station from 87.5Mhz to 108Mhz.
D. Press NEXT/PREV button to select the FM station.
To Next Page
Loading...
Need help?
General
