Pyle PDWM1902 - User Manual

Questions and Answers

A
Amanda HowellAug 10, 2025
Why is there no sound coming from my Pyle PDWM1902 Microphone system?
- R
  rachel71Aug 10, 2025
  If you're experiencing a lack of sound, ensure the transmitter's POWER ON/OFF switch is in the ON position and that the battery is correctly inserted, paying attention to the (+/-) orientation. If the battery is properly inserted, try replacing it with a fresh one. Also, check that the transmitter's MUTE/ON switch is in the ON position. Verify that the AC adapter is securely connected to both a working electrical outlet and the DC input connector, ensuring the outlet supplies the correct voltage. Increase the receiver's volume and confirm that all output connections from the receiver to your external equipment are secure. Finally, ensure the transmitter and receiver frequencies match and try moving the transmitter closer to the receiver.
J
Jennifer BrewerAug 15, 2025
What to do if bursts of noise present in Pyle Microphone system?
- M
  Molly GrimesAug 15, 2025
  If you are experiencing bursts of noise or audible radio signals, try to identify potential sources of interference (other RF sources). Turn them off, remove them, or use a wireless system operating on a different frequency.
T
Tonya ThomasAug 20, 2025
What to do if Pyle PDWM1902 Microphone system sound level differs from cabled instrument?
- J
  Jessica SchroederAug 20, 2025
  If the sound level differs from the level of a cabled instrument, adjust the transmitter gain level to compensate. You may also need to adjust the receiver volume as needed.
D
Daniel SmithAug 25, 2025
What to do if the distortion level increases gradually on Pyle Microphone system?
- L
  Lisa MitchellAug 25, 2025
  If the distortion level increases gradually, replace the transmitter battery.
N
nparkAug 30, 2025
What to do if sound level differs with different guitars on Pyle PDWM1902 Microphone system?
- W
  William LewisAug 30, 2025
  If the sound level differs with different guitars, re-adjust the transmitter gain level to compensate for differences in guitar outputs.
C
Charles WilliamsSep 3, 2025
What to do if momentary loss of sound as transmitter is moved around performing area with Pyle PDWM1902 Microphone system?
- K
  katrinakingSep 3, 2025
  If you experience a momentary loss of sound as the transmitter is moved around the performance area, reposition the receiver and perform a walk-through test again. If audio dropouts persist, mark the 'dead' spots and avoid them during the performance.

Pyle PDWM1902 Specifications

General

Type	Wireless Microphone System
Microphone Type	Dynamic
Frequency Stability	±0.005%
Modulation Mode	FM
T.H.D.	< 0.5%
Frequency Response	50Hz-15kHz
S/N Ratio	> 90 dB
Output Impedance	600 Ohm
Transmitter Power	10 mW
Max Deviation	±45kHz
Battery Voltage	3V
Continuous Using	8 hours
Transmitter Battery	2 x AA Batteries
Receiver Type	Diversity Receiver
Power Supply	DC 12V
Audio Output	Balanced and unbalanced
Dynamic Range	>100dB
De-Emphasis	50 μs
Spurious Emission	< -60 dBm