6
BODYPACK TRANSMITTER CONNECTION
TRANSMITTER BATTERY INSTALLATION
MATCHINGWIRELESS FREQUENCY
(RECEIVER /TRANSMITTER CONNECTION)
1. Lavalier Microphone Connection: Connect the connector of supplied Lavalier microphone to the
connecting jack of transmitter (Shown as below) Set the transmitter work state in wireless lavaliere system.
2. Headset Microphone Connection: Connect the connector of supplied Headset microphone to the
connecting jack of transmitter(Shown as below) Set the transmitter work state in wireless headset system.
1. Battery Installation of Transmitter: Push open the battery cover, Insert the supplied batteries into
battery jar in polarity and cover the battery Cover.
1. Press and hold the “SET” button on the receiver --- then release the button once the receiver display
begins to ash.
2. When itis ashing, continue to press the “SET” button again to select the desired channel, the
selected channel will save automatically without any action for 5 seconds.
3. Power on your microphone/transmitter, press and hold the “UP” and “ DOWN” arrow keys once the CH
number on display begins to ash.
4. When it is ashing, press “UP” and “DOWN” arrow keys to select the same channel as chosen on
receiver, then, the selected channel will save automatically without any action for5 seconds.
5. Repeat steps 1-4 to connect an additional microphone / transmitter (For models PDWM3375,
PDWM3400)
To Next Page
Loading...
