SYSTEM
OPERATION
1. Please take note of the following workow diagram for reference on connecting
this machine. Connect the mix out of receiver with mic input on the amplier or
out A, B, C, D and mic input on the amplier.
2. Make sure your system is set to the correct power (120V/240V) before switching
the unit ON. Then set the volume of your sound equipment.
3. Adjust the volume and mic so that the users of MIC 1 and MIC 2 sounds good
together.
4. Unplug the machine if you will not be using it for a long time.
SYSTEM CONNECTION FLOW DIAGRAM
RECEIVER INSTALLATION
• Keep the machine at least 3 feet above the ground and 3 feet away from walls.
• Pull the antenna upright.
• Your equipment will operate best if there is no physical barrier between the
microphone and the receiving antenna.
• Keep the receiver away from digital equipment, such as CD players, computers,
or other radio equipment.
www.PyleUSA.com
6
To Next Page
Loading...
