TROUBLESHOOTING
Some common problems and their solutions are printed below.
PROBLEM SOLUTION
No sound;
RF light(s) not
glowing
No sound;
RF light(s) not
glowing
Received signal is
noisy; contains
extraneous sounds
with transmitter on.
Noise from receiver
with transmitter o.
Momentary loss of
sound as transmitter
is moved around
performing area.
• Make sure the transmitter
• POWER switch is ON and the receiver is plugged into a
power source
• Check battery.
• Check receiver squelch setting.
• Check receiver antenna connection(s).
• Make sure antennas are in line of sight of transmitter.
• Turn up receiver audio VOLUME control
• Check for proper connection between receiver and
karaoke unit
• Check battery
• Remove local.Sources of RF interference.
• If using a guitar or other instrument, check connections.
• Two transmitters may be operating on the same
frequency. Locate and turn one o.
• Signal may be too weak, reposition antennas.
If possible, move them closer to transmitter.
• Adjust receiver squelch control.
• Remove local sources of RF interference.
• Reposition receiver or antennas.
• Reposition receiver and perform another walkthrough
test and observe the RF indicators. If audio drop outs
persist, mark these dead spots in performing area and
avoid them during performance
www.PyleUSA.com
7
To Next Page
Loading...
Need help?
General
