Pyle PLMRA210BT - Page 10

Elite Series Waterproof Amplifiers
PLMRA410BT - Wiring
Note:
Elite Series Ampshave built-in short circuit protection. If you mistakingly connect any
speaker wires to ground, or positive power ( +) and (-) Wires short together, the
protection circuit will operate automatically and cut-off output. In case of this, you must
switch OFF the whole system immediately double check speaker wire connections and
isolation before switching on the amplifier again.
Common Ground Type
Two Speaker Output Mode
Floating Ground Type
*High and Low impedance inputs
cannot be used at the same time.