Pyle PLMRA210BT - Page 11

Elite Series Waterproof Amplifiers
PLMRA410BT - Wiring
1. Connect the B+12V pole of power supply directly to the battery(+) position
terminal (In-line fuse 1 foot from battery).
2. Connect the GND pole of power supply directly to the (-) negative ground
battery terminal or vehicle chassis.
3. To make a good grounding and prevent motor boating noise problem connect
another 12 gauge minimum wire from the (-) negative battery terminal to chassis
of stereo unit.
4. Connect the 'Remote' pole to external switch for positive 12V ON/OFF. This
may be connected to the receiver power antenna lead.
Connect the speaker output terminals to the corresponding speakers.
The speakers must be high quality and capable of handling high power.
Separated return paths and strong wires are required.
Power
Connection