3. The GAIN control adjusts the overall level of the amplier. When using
the amplier without volume control the level should beset to
achieve a balance with other loudspeakers in the system. As arule,
keep the gain setting as low as possible while still insuring that the
system will reach full output power. When using the system with
external volume control, set the external Volume Control to FULL
(clockwise) and adjust the gain on the amplier until full output
power is reached. Full output power level can be determined by
turning the gain control clockwise until the apparent loudness does
not appear to increase any more. Leave the control at the setting
where this begins to become apparent.
4. VOLUME CONTROL Plug for the waterproof remote volume control.
When installed, this control will turn o the PLMRMP3A Amp when
turned all the way down.
5. INPUT Stereo RCA audio input for connecting other audio devices
www.PyleUSA.com
5
To Next Page
Loading...
Need help?
General
