Pyle PT270AIU - Safety Instructions and Features; Connection and Volume Safety; Wire Insertion and Noise Prevention; Key Product Features

PT270AIU
AM ANTENNA
FMANTENNA
-,-
I •• e ___ e •• ) I
~ ..
2MIC II g,poDor
.. PUTS / / t MP3;npu'
II
$PEAKER/lMPEDANCii
VOLTACESELECTOR
1.;4~-1lgIlPEAKEII It4g-1lgllPEAKEII
•• 8 8 ••
· 00 00 ·
~~ ' Q , I
~
n
~ 0000
R
~.~~ < ~ 9 . ~ ~ oo
' 0
Y-
O
o ~o
CDlDVD
® ® ® ®
8~
CiiiiJ9
-
M.lnSp •• bn
CD Record.r
!Ie..... =~
-
7
PT270AIU
SAFETY INSTRUCTIONS
1. Make sure that all connections are properly connected and the main
volume
is setto minimum level before turning on the unit.
2. When more then one pair of speakers are used, (specially the main
speaker
output) make sure that the speakers used are of the same
wattage and impedance, otherwise
the unit maybe damaged under
high power or long term operation.
3. To avoid humming sound s and unwanted noise, make sure that all the
wires are
properly inserted.
4. For speaker cords, strip off the vinyl coating and twist the wire tip.
Push
down the pinkjack or loosen the screw terminal, before inserting
the wire tip, then fasten it and tighten the screw. Be careful notto let
the wires stick out ofthe terminal otherwise this may causea short
circuit when wires of different terminal contact each other.
5. After the unit is turned on, adjust the main volume to the desired level
same is
true with the bass and treble volume, etc.