Enforcer 32-WE Wireless Setup Manual
Page: 7
4.2 Learning Bells
This sections shows how to learn any external sounders (bells) on to the Enforcer 32-WE.
It is recommended that all wireless bells are
learned at the Enforcer 32-WE before final
installation. This makes the learning procedure
much quicker.
A maximum of 2 wireless bells (DELTABELL-WE)
may be learned.
Even though the ‘learn’ may be successful, the
position of the bell on a property must be tested
for signal strength before it is actually ‘fixed’ into
place. Refer to page 10 when analysing the signal
strength.
Before learning each bell check that the battery is
present and is inserted correctly.
Follow the instructions to the right to start learning
the bells.
A bell that is learnt correctly will flash the GREEN
LED briefly and display ‘Bell Learnt’ on the keypad.
Both of these instances need to occur to indicate a
successful learn.
Learning Procedure.
DELTABELL-WE
Learning...
In
Press
Press
Press
Select the Bell. Press . If
‘LEARNT’ is shown on a bell,
this will need to deleted before
learning can begin.
Use
and
to scroll to:
When ‘Learning’ is displayed,
press and hold the ‘LEARN’
button on the device until the
LEDs cycle, then release.
If a bell has already been learnt
to the Enforcer system, ‘Bell
Learnt Already!’ will be
displayed. Press .
WIRELESS DEVICE
CONTROL?
Control Inputs?
Press
Control Bells?
Learn Devices?
Select Bell
Available [1]
Select Bell
Learnt [2]
Bell Learnt
Bell Learnt
Already!
To Next Page
Loading...
Need help?
General
