Python 991 - Timer Mode

29
© 2008 Directed Electronics. All rights reserved.
running. If the vehicle shuts down when locking, then the unit did not
enter valet take-over mode.
Timer mode
Command : Press two-times and then .
Feedback : 3MALLTIMERICONAPPEARSANDTEXTREADShTIMERSTARTONv
The vehicle will confirm with 4 fast parking light flash-
es.
Notes : Enables or disables the remote start timer mode.
The system must be armed for the timer mode to operate. The system
WILLSTARTEVERYHOURSFORAMAXIMUMOFSIXCYCLESUNTILCANCELEDBYTHE
brake, hood, or neutral safety shut-down wires. The remote will respond
with the Start and Stop remote start notification during each Start and
3TOPOFTHE6EHICLEWHILEIN4IMERMODE
Important: Use Timer Mode in open areas only. Never start
and run the vehicle in an enclosed space such as a garage
or carport.
To activate timer mode with a manual transmission:
Enter the MTS mode.1.
%XITTHEVEHICLEANDARMTHEALARM2.
Enter the timer mode. The parking lights quickly flash 4 times to confirm 3.
ENTRYINTOTIMERMODEVEHICLEDOESNOTREMOTESTARTATTHISPOINT6EHICLE
begins the timer mode sequence.
To exit timer mode with transmitter:
Press s
twice and then press . Parking lights flash slowly four times
CONlRMINGTIMERMODEISEXITED
To exit timer mode without transmitter:
Make sure the remote start system is not operating the engine.1.