Python 991 - Manual Transmission Remote Start

28
© 2008 Directed Electronics. All rights reserved.
Additional remote start features
Manual Transmission
If the vehicle has a manual transmission the proper steps must be fol-
lowed before leaving the parked vehicle or the remote start feature is
disabled.
Make sure the engine is running and the doors on the vehicle are 1.
closed.
Put the transmission in neutral.2.
Press on the brake in the vehicle.3.
Apply the emergency brake.4.
Release the brake.5.
Note: Pressing the brake pedal again after this step will disable the
remote start feature.
Within 15 seconds activate the remote start from the remote.6.
The parking lights flash 5-times confirming that the remote start is 7.
active. If the parking lights do not flash 5-times, then repeat steps
1 - 6.
Turn off the ignition (the car stays running when key is turned off).8.
%XITTHEVEHICLE9.
Arm the alarm (the vehicle should shut off when arming the sys-10.
tem).
You can now remote start the vehicle. If a door is opened or the alarm
ISTRIGGEREDBEFORETHENEXTREMOTESTARTACTIVATIONTHESYSTEMWILLNOT
remote start.
Note: 4OENABLE6ALETTAKEOVERWITHAMANUALTRANSMISSIONOPENTHE
door and enter into manual transmission mode, as described above.
4HEPARKINGLIGHTSmASHONETIMEWHENENTERING6ALETTAKEOVER/NCE
YOUEXITTHEVEHICLEYOUCANLOCKTHESYSTEMANDTHECARWILLREMAIN