46
© 2008 Directed Electronics. All rights reserved.
Power saver mode
System
Your system will automatically enter Power Saver Mode while armed or
IN6ALET-ODEAFTERAPERIODOFTIMEINWHICHNOOPERATIONHASBEEN
performed. This lowers the current draw on the vehicle’s battery. Power
Saver Mode takes over under the following conditions:
Power Saver when the system is armed:
After the system has been
armed for 24 hours the LED will flash at half its normal rate, decreasing
the system’s current draw.
Power Saver in Valet Mode:
7HENTHESYSTEMENTERS6ALET-ODETHE
Status LED on the Responder LE control center illuminates steadily. If the
vehicle is not used (ignition is not turned on) for a one hour period while
THESYSTEMISIN6ALET-ODETHESTATUS,%$WILLSHUTOFF)FTHESYSTEM
REMAINSIN6ALET-ODETHE,%$WILLCOMEBACKONTHENEXTTIMETHE
ignition is turned on and then back off.
2-way remote
Your Responder LC 2way remote control has a feature called remote
power save mode. When programmed ON under remote options, the
remote will conserve power by disabling the paging function if unused
for more than 72 hours. Pressing any button on the remote will restore
the paging function.
The default setting is ON. See Remote control programming section of
this guide or ask your dealer for details on how to program.
To Next Page
Loading...
Need help?
General
