51
© 2008 Directed Electronics. All rights reserved.
Glossary of terms
2-Way Remote:
A hand-held, remote control which operates the
various functions of your system and receives feedback and pages from
the alarm system.
Control Center:
The control center contains the system’s radio-frequency
antenna, the valet and override switch, and the Status LED.
&OR MAXIMUM REMOTECONTROL RANGE THE #ONTROL #ENTER IS USUALLYLO-
cated at the top of the windshield, centered near the rear-view mirror.
Control Module:
4HEhBRAINvOFYOURSYSTEM5SUALLYHIDDENUNDERNEATH
the dash area of the vehicle. It houses the microprocessor which moni-
tors your vehicle and controls all of the alarm’s Functions.
Failsafe® Starter Kill
(if equipped): An automatic switch controlled by
the security system which prevents the vehicle’s starter from cranking
whenever the system is armed. The vehicle is never prevented from
CRANKINGWHENTHESYSTEMISDISARMEDIN6ALET-ODEORSHOULDTHE
starter kill switch itself fail. Your system is ready for this feature, however
installation of this feature may require additional labor.
Input:
Any physical connection to the security system. An input can
BEPROVIDEDTHROUGHASENSORPINSWITCHORBYEXISTINGSYSTEMSINTHE
vehicle, such as ignition or courtesy lights.
In-vehicle status LED:
A light used to indicate the status of your system.
It is located on your systems control center.
Shock Sensor:
This system has a dual zone shock sensor. This
sensor is mounted in the vehicle and designed to pick up impacts
To Next Page
Loading...
Need help?
General
