To Next Page

To Previous Page

Note:

Bypass Notiﬁcation does not occur when the system is in Silent

Mode or if the notiﬁcation chirps have been programmed off by the

installer.

 Disarming

%XTRACHIRPSHEARDWHENDISARMINGTHESYSTEMARETHE4AMPER!LERT

If four chirps are heard when disarming the system, then the security

system was triggered in your absence.

If ﬁve chirps are heard when disarming the system, the system was

TRIGGEREDSOMANYTIMESTHATTHE.UISANCE0ROTECTION#IRCUITRYHAS

bypassed the intended zone. In either case, the status LED will indicate

which zone was involved (see Table of Zones).

The security system will retain this information in its memory, and chirp

FOURORlVETIMESEACHTIMEITISDISARMEDUNTILTHENEXTTIMETHATTHE

ignition is turned on.

Note concerning low battery alert:

When the batteries in the remote

are low the alarm will give an additional chirp when disarming to let

you know its time to change the battery in the remote.

 System status chirps

4HESIRENWILLCHIRPWHENARMINGDISARMINGTHESYSTEM4HEPATTERNOF

chirps will audibly report the system’s status as described below.

Action Number of Chirps Description

Arm 1 System armed

Arm 1 (3-second delay) + 1 System armed with bypass notification

Disarm 2 System disarmed

Python 991 User Manual

Questions and Answers: