Why Q'STRAINT QLK unit clicks but doesn't energize solenoid when dash control pressed?
If the QLK unit clicks when the Dash Control is pressed but doesn't energize the solenoid for 8-10 seconds, ensure the voltage supplied to the QLK system is at least 12V when drawing 10A with the ignition OFF. The voltage supplied to the QLK system MUST be minimum 12V when drawing 10A with the ignition OFF.
What to do if green light is on when Q'STRAINT Docking Station is off?
If the vehicle is off, and the wheelchair is not in the Q'STRAINT Docking System, but the green light on the Dash Control is still on, press the Release Button or the Auxiliary Release Switch. This will open the Docking System and turn off the green light on the Dash Control.
How to fix Q'STRAINT Docking Station if the dash control is not working?
If the Dash Control of your Q'STRAINT Docking Station is not working, check that the Dash Control Wire Harness is connected to the Electronic Control Module (ECM). Also, ensure that the surface is flat, as any curvature can affect the Dash Control.
What to do if the red light on Q'STRAINT Docking Station turns on and off?
If the red light on your Q'STRAINT Docking Station Dash Control turns on and then off, it means the wheelchair isn't secured in the Docking System, and the Locking Pawl is still open. Make sure to properly secure the wheelchair in the Docking System.
Why is the green light on my Q'STRAINT Docking Station Dash Control not turning on?
If the green light on the Q'STRAINT Docking Station Dash Control won't turn on, it could be because the wheelchair isn't fully secured, meaning the Locking Pawl is still open. Alternatively, the Dash Control Wire Harness might not be properly connected to the Electrical Control Module (ECM). Ensure the wheelchair is secured, and check the connection of the Dash Control Wire Harness to the ECM.
How to manually release a wheelchair from Q'STRAINT Docking Station?
To manually release the wheelchair from the Q'STRAINT Docking Station, push the Manual Release Lever. This will open the Locking Pawl and release the wheelchair.
What to do if Q'STRAINT Docking Station does not open with Dash Control/aux release switch?
If the Q'STRAINT docking system doesn't open when you use the Dash Control or auxiliary release switch, check that the voltage supplied to the QLK system is more than 12V when QLK is activated. Also, ensure that the docking bolt/bracket isn't applying pressure to the locking pawl.
General| Brand | Q'STRAINT |
|---|---|
| Model | QLK-150 |
| Category | Wheelchair |
| Language | English |
To Next Page
