z z z z z z z
31
Replacing the batteries of the remote control
If the LED is flashing red while sending the batteries are nearly flat. In this
case open the housing by removing the six screws. Turn the screws until they
run free. Take the back case off and replace the batteries with new ones.
Always use 3 new batteries size AA (LR6) of the same type. Do not mix new
and old batteries, as their lifetime will decrease.
Before closing check the correct position of the sealing and that it is free from
dirt. Now close the housing and fix the six screws to make sure that the RC is
waterproofed.
To Next Page
Loading...
Need help?
General