C. EXTENSION CORDS
1.
Use only extension cords that are intended for
outdoor use. These extension
cords are identified
by a
marking
"Acceptable
for
use
with
outdoor appliances, store indoors
while not in use." Use
only
recommended
extension
cords. Do not use damaged
extension cords. Examine extension
cord before using and replace if
damaged. Do
not
abuse extension cords and do not
yank
on any cord to disconnect. Keep
cord away from heat
and sharp
edges. Always
disconnect the extension cord from the receptacle
before disconnecting
the
product
from the
extension cord.
2.WARNING
-
To reduce the risk of electrocution, keep
all connections dry and off
the
ground.
Do not touch the
plug
with wet ha nds.
3.Ground Fault Circuit Interrupter
(GFCI)
protection
should be
provided
on the circuit(s) or outlet(s)
to be used
for
the saw. Receptacles are available having
built-in GFCI
protection
and may be used for
this measure of safety.
D. FOR YOUR OWN SAFETY READ THE
OWNER'S
MANUAL
BEFORE OPERATING THE
SAW
.
Wear eye
protection.
.
Keep
blade safety
guard
in
place.
.
Disconnect
the saw before servicing, when changing diamond
blades and cleaning.
.
Make certain
that
you
use the
appropriate bade
foi'the
materialthat
you
are cuttirg.
.
Replace
damaged blades before operating.
.
Do not fill water tray above the max water filling line.
E. SPECIFIC OPERATION GUIDE
1. Ensure that the directional
arrow
marked
on the blade corresponds with the rotational
direction of the motor.
2. With
the saw disconnected from the
power
supply, rotate the blade
by
hand
to ensure it is free
from obstruction.
3. Always keep
the blade-securing arbor and collars clean.
4. Ensure
that the blade-securing bolt is securely tightened.
5.
Never
try to cut freehand. Always ensure that the tile to
be
cut is
pressed
firmly
against the rip fence.
6. Ensu re that the workpiece that will
be cut off
has
sufficient room to move sideways. Failure
to do so may
result
in
the off-cut binding against the blade.
7. Never
cut more than one tile at a time.
8. Never cut
pieces
too small that
are
not held
securely against the rip fence, and
provide
enough space
for
the
hand
to be a safe distance
from
the blade.
9. Ensure that the table and surrounding
area are clear
with
the exception of the tile to be cut.
10. Before cutting a tile
piece,
let
the saw blade
run
freely for a few seconds. lf it makes
an unfamiliar sound or
vibrates excessively, switch it
off
immediately
and disconnect it from the
power
supply.
11. Let
the blade
reach full
speed before commencing the cut.
12. Let the blade come to a
complete stop before removing any
jammed
material from
around the
blade area.
13. Never
allow the blade to run dry. Failure to keep
the
water
tray at the
recommended
level will result in
possible
over-heating of the diamond
blade.
-5-
To Next Page
Loading...
