To Next PageTo Next Page
Need help?Do you have a question about the QEP Brutus 60010 and is the answer not in the manual?
General| Blade Diameter | 10 inches |
|---|---|
| Voltage | 120 V |
| Arbor Size | 5/8 inch |
| Weight | 12.8 lbs |
| Amperage | 15 A |
Maintain a clean, secure workspace and follow safe operating procedures.
Wear PPE, use correct electrical connections, and avoid wet conditions.
Maintain tools properly, use correct blades, and follow blade safety rules.
Position saw to prevent water contact with plugs/receptacles and ensure drip loop.
Connect to grounded source, use proper extension cords, and follow electrical safety rules.
Use outdoor-rated, heavy-gauge extension cords with 3-prong plugs.
Ensure GFCI protection and keep connections dry.
Ensure correct blade direction, free rotation, and secure mounting.
Support material, allow space for off-cuts, and avoid cutting small pieces.
Ensure a clear area, check blade condition, reach full speed, and maintain water flow.
Welcome to the Brutus 60010 Tile Saw, a high-quality flooring installation tool.
Identifies key components of the Brutus 18" Tile Saw.
Carefully unpack and verify all saw components are present.
Read and follow safety warnings before operating the saw.
Instructions for assembling the folding saw stand.
Steps to securely attach the saw frame to the assembled stand.
Procedure for attaching the cutting head to the motor support arm.
How to install or change the diamond blade safely.
Procedure for attaching the blade guard before blade installation.
Steps to connect the water pump, tubing, and power.
Instructions for placing and filling the water tray.
Guidelines for safe electrical connection and handling of the water pump.
Proper operation, water level checks, and intake screen cleaning.
Procedure for changing motor speed and adjusting belt tension.
How to set the recommended cutting depth for the blade.
Key recommendations for inspecting and using diamond blades.
Important 'don'ts' for using diamond blades to prevent damage or injury.
Instructions for making straight cuts using the rip guide.
Procedure for making 45-degree angle cuts using the rip guide.
Instructions for performing miter cuts using the miter block.
How to align the cutting table for accurate cuts.
Method to refresh diamond blade cutting efficiency.
Guidelines for cleaning exterior, cutting table, and pump.
Diagnosing and resolving saw overheating problems.
Troubleshooting steps for a saw that does not start.
Addressing issues with the water pump's water flow.
Solutions for a rough or uneven cutting table surface.
List of all parts with corresponding part numbers for the tile saw.
