What to do if my QEP 900 XT PRO motor does not start?
If your QEP Saw's motor isn't starting, first ensure the power cord is properly plugged into the socket. If that's not the issue, verify there is electrical power at the outlet. Other potential causes include a switch failure, requiring a switch replacement, or worn brushes, which should be replaced as well. See the MAINTENANCE section for guidance on brush replacement.
Why is my QEP 900 XT PRO Saw vibrating or shaking?
If your QEP Saw is vibrating or shaking, it could be due to a saw blade that is not round, damaged, or loose, in which case you should replace the blade. Another possibility is that the blade is not tightened on the saw, or the arbor bolt is loose. Ensure you tighten the arbor bolt.
Why is my QEP 900 XT PRO Saw overheating?
If your QEP Saw is overheating, it might be operating too long under pressure. Turn the saw off and allow it to rest until the motor is cool to the touch. Another reason could be a blockage or dirt jammed in the ventilation slots of the motor. Check and clean these slots to remove any obstructions.
What to do if the pump is not flowing water in my QEP Saw?
If the pump in your QEP Saw isn't flowing water, it might be due to insufficient water. Add water until the pump is completely submerged. Alternatively, the water hose could be jammed with dirt, requiring you to clean it.
Why the laser guide or LED light fails to turn on my QEP Saw?
If the laser guide or LED light on your QEP Saw fails to turn on, the batteries might be dead. Replace them with new AAA batteries. Also, the battery contacts might need adjustment. Reload the batteries and ensure they make solid contact with the battery spring.
How to make cutting table smooth on QEP 900 XT PRO Saw?
If the cutting table of your QEP Saw is not smooth, it's likely due to dirt jammed on the guide rails or cutting table rollers. Clean the dirt and spread some machine oil on the guide rails.
Why does the brush spark when switch released on my QEP Saw?
If you observe brush sparking when you release the switch on your QEP Saw, it may be due to worn brushes. In this case, replace the brushes. See the MAINTENANCE section.
Explains safety icons and defines hazard levels (Danger, Warning, Caution).
Fundamental safety rules for operating power tools.
Details critical practices like wearing eye protection and securing work.
Essential safety steps before using the wet tile saw.
Details important warning labels on the tile saw.
Covers safe electrical connection, grounding, and extension cord use.
Guidance on placing the saw to prevent water contact with electrical parts.
Lists assembly tools and instructions for unpacking and checking parts.
Identifies and labels key parts of the tile saw.
Instructions for assembling the stand, wheels, and setting it up.
Steps to mount saw, fold stand, and transport the unit.
Instructions for assembling motor arm, cutting head, blade, and guards.
Guide for installing water trays, pan, and pump.
Checking and adjusting blade alignment, 90° and 45° angles.
Adjusting blade depth and replacing laser batteries.
Operation, safety, and alignment procedures for the laser guide.
Verifying and adjusting laser beam accuracy using adjustment screws.
Steps before use, and details on LED and ON/OFF switches.
How to adjust and use the rip/angle guide for cuts.
Procedures for adjusting head height, bevel, and locking the table.
Using the extension table and performing straight cuts.
Steps for performing a diagonal cut on a tile.
Instructions for performing bevel, angle, and plunge cuts.
Guide on replacing brushes and cleaning the saw.
Lists common issues and suggested corrective actions for the tile saw.
A diagram showing all parts of the tile saw.
Comprehensive list of parts for the tile saw with IDs and descriptions.
Comprehensive list of parts for the stand with IDs and descriptions.
To Next Page
General
