5
1.
2. against the miter
gauge or quick-locking cutting guide.
3.
to support or guide the
workpiece.
4. or have any part of your body in
line with the path of the wet tile saw blade.
5. behind or over the wet tile saw for
any reason.
6.
against the direction of rotation only.
7.
without rst turning the
saw OFF and unpluging it from the wall outlet. Turn
power switch OFF immediately to prevent motor
damage.
8. to the rear
and the sides of the wet tile saw for long or wide
workpieces.
9. and hand
positions where a sudden slip could cause your
hand to move into the saw blade.
10. to clean plastic parts.
Solvents could possibly dissolve or otherwise
damage the material. Only a soft, damp cloth should
be used to clean plastic parts.
11. MOUNT your tile saw on a bench or stand before
performing any cutting operations. Refer to
WARNING
!
12.
Remove dust frequently. Clean out dust from the
interior of the saw to prevent a potential re hazard.
13.
Do not leave the saw until it comes
to a complete stop.
14. (work thrown back towards
you) by keeping the blade sharp, the miter gauge
and cutting guides parallel to the saw blade and
by keeping the guards in place, aligned and
functioning. Do not release work before it has
passed all the way through the saw blade. Do not
rip work that is twisted, warped or does not have a
straight edge to guide it along the guides.
15. Find and read all the warning labels from the tool
(shown below)
Laser warning label
Laser aperture label
To Next Page
