QEP 83200 - Maintenance; Troubleshooting; Accessories Included with Saw

C. Use the
hexagonal
wrench
to hold the blade
nut
and use the spanner
wrench
provided
to
hold the shaft.
Loosen
the
nut
turning
clockwise as
in
(Fig
18).
D. Ensure that the shaft and
flanges
are clean.
Mount blade back on to shaft ensuring that
the directional
arrow on the blade
is rotating
towards the
material
to be cut.
E.
Insert flange and lock nut. Tighten
counterclockwise.
Figure
18
MAINTENANCE
CAUTI0N!
While
doing
maintenance
on
the
saw,
always
pull
the
plug
out of
the
electrical socket.
1. Never use water or any other
chemicals to clean the electrical
parts
of the machine.
2. Use a soft cloth
to clean and dust the
machine.
3.
Keep
the
ventilation slots
of the motor clean to
prevent
overheating
of the
motor.
4. Dry
the saw.
A. Periodic maintenance of the
saw will
prevent
unnecessary
problems.
B.
Keep
the
ventilation slots of the
saw clean to
prevent
overheating
of the
motor.
C.
Dry the saw as
much as
possible
after each
use.
TROUBLESHOOTING
1. Overheating
of saw;
A.
Turn
bridge
saw off and
let it rest
until
motor
is
B.
Check
and clean
the
ventilation
slots,
removing
2. The saw does
not start;
A. Check that
power
cord
is
properly plugged
in.
B. No
power
from
outlet.
C. Switch
is damaged.
ACCESSORIES
INCLUDED WITH SAW
1. Hexagonal
Blade
Wrench
2. Motor Shaft
Holding
Wrench
3.
Steel Shelf
4.
Water Pump
5. S" Continuous
Rim Diamond Bladc
cool to the
touch.
blockage and
dirt.