EasyManuals Logo

QIDI I-mate User Manual

QIDI I-mate
21 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
8. The installation is completed
as shown in the picture.
7. Thread the filament into the
extruder.
If need to close the pull rod, push
the spring button opposite direc-
tion firstly, then push down the
pull rod.
1
2

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the QIDI I-mate and is the answer not in the manual?

QIDI I-mate Specifications

General IconGeneral
Nozzle Diameter0.4 mm
Filament Diameter1.75 mm
Supported FilamentsPLA, ABS, TPU
Bed LevelingManual
Extruder TypeSingle Extruder
Print TechnologyFDM (Fused Deposition Modeling)
Heated BedYes
Nozzle TemperatureUp to 250°C
Layer Resolution0.05 - 0.3 mm
Print Speed30-150 mm/s
ConnectivityUSB, Wi-Fi
Frame MaterialMetal

Related product manuals