EasyManuals Logo

QIDI I-mate User Manual

QIDI I-mate
21 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
4. Remove the protective film on
the outside of the machine.
5. Cut off the cable tie on the
right Y axis.
6. Cut off the cable tie on the left
Y axis.
2. Take out the instructions and
take out the foam.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the QIDI I-mate and is the answer not in the manual?

QIDI I-mate Specifications

General IconGeneral
Nozzle Diameter0.4 mm
Filament Diameter1.75 mm
Supported FilamentsPLA, ABS, TPU
Bed LevelingManual
Extruder TypeSingle Extruder
Print TechnologyFDM (Fused Deposition Modeling)
Heated BedYes
Nozzle TemperatureUp to 250°C
Layer Resolution0.05 - 0.3 mm
Print Speed30-150 mm/s
ConnectivityUSB, Wi-Fi
Frame MaterialMetal

Related product manuals