QIDI I-mate User Manual

When the user is exchanging the filament, the user
needs to use the unload function as described below:
1. Click“Tool”icon.
5. Hold down the filament
buckle and slowly pull out
the filament.
4.Click“Stop”icon.
3. Wait for the temperature to
reach 220℃, and then click the
down icon①. When the filament
starts to come out from the
extruder click on the return
icon②.
2. Click“Filament”icon.

QIDI I-mate Specifications

General

Nozzle Diameter	0.4 mm
Filament Diameter	1.75 mm
Supported Filaments	PLA, ABS, TPU
Bed Leveling	Manual
Extruder Type	Single Extruder
Print Technology	FDM (Fused Deposition Modeling)
Heated Bed	Yes
Nozzle Temperature	Up to 250°C
Layer Resolution	0.05 - 0.3 mm
Print Speed	30-150 mm/s
Connectivity	USB, Wi-Fi
Frame Material	Metal