4
85
TO SWITCH ON THE UNIT AT A CERTAIN TIME
• Ensure that the unit is set in the required operating mode
,
of
.
• Switch off the unit by pressing the
-button. Ensure that the plug is
properly inserted into the wall outlet.
• Press the
-button. The light “Timer set” will flash.
• Use the
and buttons to set a time between 1 and 24 hours.
• When the set time has expired the unit will switch on.
SWITCHING OFF
• While the device is running, press the
button.
• The ‘Timer set’ indicator will light up.
• Now use the
and buttons to set a time between 1 and 24 hours.
• Once the set time has passed the device will switch off.
TO SWITCH OFF THE UNIT AT A CERTAIN TIME
• When the unit is operating in the required mode press the -button. The
light “Timer set” will flash.
• Use the
and buttons to set a time between 1 and 12 hours.
• When the set time has expired the unit will switch off.
G
NOTE!
The compressor has been set so that it starts functioning three minutes
after the (re)start of the air conditioner.
The cooling will switch off when the room temperature is lower than
the set one. Air circulation will however continue to work on the set
level. When the room temperature rises above the selected value, the
cooling will work again.
SLEEP
6
By pressing the Sleep button the sleep function is activated. The sleep function can
only be activated in the Cool mode. After activating the sleep function, the set
temperature will increase by 1 ºC after one hour’s operation. After two hours’ ope-
ration the set temperature will be increased by another 1 ºC. The air conditioner
will now continue to operate at this temperature.
E REMOTE CONTROL
a. On/Off button
b. Timer and set point adjustment button
c. Fan speed button
d. Sleep function button
e. Timer function button.
f. Button activating fan continuation after switching off unit
g. Function selector button
Fig. 9
Fig. 8
E
F
G
E
C
B
A
To Next Page
Loading...
Need help?
General
