Qlima P 426 - Page 89

4
89
1
Remove the condensation cover at the rear of the unit by turning it anti-
clockwise and remove the rubber cap from the drain (see fig. 14).
Fig. 14
2
Connect the supplied hose grommet H (see fig. 1) to this drain (see fig. 15).
Fig. 15
3
Join the water hose (not supplied) to the hose grommet (see fig. 16).
Fig. 16
4
Make sure that the condensation hose is connected to a drain or collection
tank.
5
Make sure that the drain hose does not hang in the water and that it always
runs downwards (see fig 17).
Fig. 17
Fitting power cable clips
1
Fit the supplied cable clips E with the screws F (see fig. 1) to the rear of the air con-
ditioner (see fig 18).