66
4
• Shut off the valve at the gas cylinder and/or
the regulator:
a. before moving the appliance
b. after use
• The tubing or the flexible hose must be
changed within the prescribed intervals
• Use only the type of gas and the type of cyl-
inder specified by the manufacturer
• In case of violent wind particular attention
must be taken against tilting of the appli-
ance
• Have any repairs and/or maintenance carried
out by a recognized service engineer only
• Make sure that the correct gas is used and
that the gas containers are not exposed
to heat or extreme temperature changes.
Always store the gas containers in a cool, dry
and dark place.
• Always use a suitable and approved low-pres-
sure regulator. In case of any doubt contact
your local dealer.
• Use only the type of gas and the type of cyl-
inder specified by the manufacturer.
• In case of violent wind particular attention
must be taken against tilting of the appli-
ance
• The tubing or the flexible hose must be
changed within the prescribed intervals
• Turn of the appliance immediately if smell of
any gass is detected and extinguish any open
flame.
ASSEMBLING THE HEATER
The manufacturer is not responsible for any harm or damage if attention is not
paid to the points described above.
The use of this product and the elements required for that purpose is entirely at
the end user’s own risk.
HEATER LOCATION AND CLEARANCE
Always maintain: (Pic.1)
- 120 cm clearance from combustible materials,
To Next Page
Loading...
Need help?
General
