EasyManuals Logo

Qlima SPHP 130 User Manual

Qlima SPHP 130
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #41 background imageLoading...
Page #41 background image
41
4
LOCATION
The heat pump should be located at least 2.5 meter away from the swimming pool.
Please comply with the following rules concerning the choice of heat pump location.
1. The unit’s future location must be easily accessible for convenient operation and maintenance.
2. It must be installed on the ground, laid ideally on a level concrete floor. Ensure that the floor is suffi-
ciently stable and can support the weight of the unit.
3. Check that the unit is properly ventilated, that the air outlet is not facing the windows of neighboring
buildings and that the exhaust air cannot return. In addition, provide sufficient space around the unit
for servicing and maintenance operations.
4. The unit must not be installed in an area exposed to oil, flammable gases, corrosive products, sulfurous
compounds or close to high frequency equipment.
5. To prevent mud splashes, do not install the unit near a road or track.
6. To avoid causing nuisance to neighbors, make sure the unit is installed so that it is positioned towards
the area that is least sensitive to noise.
7. Keep the unit as much as possible out of the reach of children.
Place nothing less than 1,50 m in front of the heat pump.
Leave 30 cm of empty space around the sides and rear of the heat pump.
Do not leave any obstacle above or in front of the unit!
Q_man_SPHP 130 ('21) V6.indd 41Q_man_SPHP 130 ('21) V6.indd 41 21-12-20 14:1521-12-20 14:15

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Qlima SPHP 130 and is the answer not in the manual?

Qlima SPHP 130 Specifications

General IconGeneral
Best uses-
Control typeButtons
Product typeElectric pool heater
Product colorBlue
Easy to installYes
Buttons quantity4
Pool capacity (max)16000 L
Pool capacity (min)- L
Units of measurement°C
Maximum heating capacity2.8 °C/h
Minimum pumping capacity2 m³/h
Temperature measurement range15 - 40 °C
Coefficient of performance (COP)4.83
International Protection (IP) codeIPX4
Operating temperature (T-T)8 - 43 °C
Motor power580 W
Input voltage220 - 240 V
Input frequency50 Hz
Weight and Dimensions IconWeight and Dimensions
Depth400 mm
Width385 mm
Height280 mm
Weight18000 g

Related product manuals