Qlima SPHP 130 User Manual

46
WARNING
Under normal conditions, a suitable heat pump can heat the water in a swimming
pool by 1°C to 2°C per day. It is therefore quite normal to not feel any temperature
difference in the system when the heat pump is working.
A heated pool must be covered to avoid any loss of heat.
G MAINTENANCE AND SERVICING
WARNING
Before undertaking maintenance work on the unit, ensure that you have
disconnected the electrical power supply.
Cleaning
The heat pump’s casing must be cleaned with a damp cloth. The use of detergents or other
household products could damage the surface of the casing and affect its properties.
The evaporator at the rear of the heat pump must be carefully cleaned with a vacuum
cleaner and soft brush attachment.
Annual maintenance
The following operations must be undertaken by a qualified person at least once a year.
• Carry out safety checks.
• Check the integrity of the electrical wiring.
• Check the earthing connections.
• Monitor the state of the pressure gauge and the presence of refrigerant.
Winter storage
Your heat pump is designed to operate in rainy weather conditions and withstand frost using
a specially created anti-frost technology. However it is not recommended to leave it outside
for long periods of time (eg over winter). After draining down the pool for the winter,
store the heat pump in a dry place.
WARNING
Under normal conditions, a suitable heat pump can heat the water in a swimming
pool by 1°C to 2°C per day. It is therefore quite normal to not feel any temperature
difference in the system when the heat pump is working.
A heated pool must be covered to avoid any loss of heat.
4
Q_man_SPHP 130 ('21) V6.indd 46Q_man_SPHP 130 ('21) V6.indd 46 21-12-20 14:1521-12-20 14:15

Qlima SPHP 130 Specifications

General

Best uses	-
Control type	Buttons
Product type	Electric pool heater
Product color	Blue
Easy to install	Yes
Buttons quantity	4
Pool capacity (max)	16000 L
Pool capacity (min)	- L
Units of measurement	°C
Maximum heating capacity	2.8 °C/h
Minimum pumping capacity	2 m³/h
Temperature measurement range	15 - 40 °C
Coefficient of performance (COP)	4.83
International Protection (IP) code	IPX4
Operating temperature (T-T)	8 - 43 °C
Motor power	580 W
Input voltage	220 - 240 V
Input frequency	50 Hz

Weight and Dimensions

Depth	400 mm
Width	385 mm
Height	280 mm
Weight	18000 g