83 BC0154503-00 C
B Dell Z9100 Switch
Configuration
The QL45212 Adapter supports connections with the Dell Z9100 Ethernet Switch.
However, until the auto-negotiation process is standardized, the switch must be
explicitly configured to connect to the adapter at 25Gbps.
To configure a Dell Z9100 switch port to connect to the QL45212 Adapter at
25Gbps:
1. Establish a serial port connection between your management workstation
and the switch.
2. Open a command line session, and then log in to the switch.
Login: admin
Password: admin
3. Enable configuration of the switch port.
Dell> enable
Password:xxxxxx
Dell# config
To Next Page
Loading...
