3 – Managing Fabrics
Zoning
3-30 59264-02 A
S
Select a port/device in the Port/Device tree, and drag it into the zone.
To select multiple ports/devices, press the Control key while selecting.
Select a port/device in the Port/Device tree. To select multiple
ports/devices, press the Control key while selecting. Select a zone set
in the left pane. Open the Edit menu and select Add Members.
Select a port/device in the Port/Device tree. To select multiple
ports/devices, press the Control key while selecting. Select a zone set
in the left pane. Click the Insert button.
If the port/device you want to add is not in the Port/Device tree, you can add
it by doing the following:
a. Right-click the selected zone.
b. Open the Edit menu and select Create Members.
c. Select the WWN, Domain/Port, or First Port Address option.
d. Enter the hexadecimal value for the port/device according to the option
selected: 16 digits for a WWN member, 4 digits for a Domain/ Port
member (DDPP), or a 6-digit Fibre Channel Address for a First Port
Address member (DDPPAA) where D=domain ID, P=port number, and
A=ALPA.
3. Click the Apply button to display the Save Zoning & Error Check dialog.
4. Click the Perform Error Check button to have the application check for
zoning conflicts, such as empty zones, aliases, or zone sets.
5. Click the Save Zoning button to implement the changes.
6. Click the Close button to close the Error Check dialog.
7. On the Edit Zoning dialog, click the Close button to close the Edit Zoning
dialog.
NOTE:
Domain ID conflicts can result in automatic reassignment of switch domain
IDs. These reassignments are not reflected in zones that use domain ID/port
number pair to define their membership. Be sure to reconfigure zones that
are affected by a domain ID change.
To Next Page
Loading...
Need help?
General
